095 PAPER STAND MANUAL

Parts:

(1) Metal Stand

(1) Plastic Paper Holder

(1) Screw

Tools Required:

- Screwdriver

- Pliers (If you are mounting on edge of table)

(fig.1) Tab placed over edge of cart

Directions:

1) Decide if stand will be mounted on the edge of the workspace surface or a work cart.

2) With pliers, bend the tab down. (fig.1) This part will hang over the edge of the table or cart to prevent the stand from moving forward when paper is fed through the printer.

3) Insert the screw into the hole of the circular part of the stand from the right side. From the left side twist the plastic paper holder onto the screw. Once you have it started use a screwdriver to tighten.

4) Place the stand behind your printer. (fig.2) The tab should be on the side away from the printer.(fig.1) If you’re using the edge of the table and performed step 2, the tab should go over the edge of the table. Place the roll of 095 paper on the plastic paper holder. Position the roll so the paper runs over, then under and through the printer. Look at picture on back. If no print shows on the paper when you print a tag, you probably positioned the paper on backwards.

(fig.2) Stand and printer on cart with paper loaded

5) You must change the format of your computer to the 095 paper. For the Barcode Tagger 600, 610, & 700 you do this by selecting choice ‘8’ from the main menu.